Operators based within 12 miles of Mount Juliet

Listed by where the business is, not by who it says it serves. Every operator here holds a current state permit, and the address it is placed by comes from the state's own published list — so this is a checkable claim rather than a service-area promise. A Tennessee installer permit is valid statewide, so operators further out can work here too; these are simply the ones closest to you.

Soil and septic suitability around Mount Juliet

The USDA has already rated this ground for exactly one use: a septic tank absorption field. Within 4 miles of Mount Juliet — 32,013 acres across 65 soil map units — it rates 82.2% of the land very limited for that use and 10.9% somewhat limited, and almost none with no limitation at all.

• Very limited · 82.2%
• Somewhat limited · 10.9%
• Not rated · 6.9%

What the limitation actually is

A rating on its own tells you nothing you can act on. The reasons do, and around Mount Juliet the leading one is depth to bedrock on 65.9% of the mapped area, followed by slow water movement on 53.8%. In full:

Shares overlap: most soils here are limited for more than one reason at once, so these do not sum to 93.1%.

The soils themselves

The named soils and land types that make up most of the ground around Mount Juliet. Talbott alone accounts for 23.6% of it.

“None in profile” means SSURGO records no bedrock or other restrictive layer within the depth it describes, not that none exists.

What that means if you are building or repairing here

Shallow bedrock

This is limestone country, and around Mount Juliet the rock is close enough to the surface to be the governing constraint. A drain field is a shallow excavation: the trench has to sit in natural soil, with room beneath it for effluent to move down and be treated. Rock under the trench does not treat anything, and it cannot be solved by digging deeper or by blasting — breaking rock produces a hole, not a soil profile. What a shallow site usually means in practice is a shallow-placement or low-pressure pipe design, imported fill, or a field sited well away from the house on whatever part of the lot runs deepest — which is why a soil map is worth having before you decide where the house goes.

Slow-draining soil

The ground around Mount Juliet holds water. Tennessee measures this as an absorption rate in minutes per inch, and slow soil does not fail a site so much as enlarge it: the slower the rate, the more trench length the same household needs, and past a point a conventional field stops being approvable at all. A slow site is normally still buildable on a low-pressure pipe or drip design, and that is the point at which the installer list matters, because most licence holders in Tennessee are not endorsed for either.

Area of interest: a 4-mile radius around the USGS Geographic Names centre point for Mount Juliet (GNIS 1294652, 36.2001, -86.5186), chosen because five of this state's communities are unincorporated and have no boundary to use, and because the lots that need a septic permit are in the ring around a town rather than inside it. Soil from USDA-NRCS Soil Data Access, SSURGO interpretation “ENG - Septic Tank Absorption Fields”, area-weighted by mapped acreage and by each component's share of its map unit. Survey areas: Davidson County, Tennessee (2025-08-28), Wilson County, Tennessee (2025-09-02). Retrieved 2026-09-09.

This is a survey, not a soil map for your lot. A permit needs a high-intensity map of the specific parcel, produced by a TDEC-approved soil consultant — see soil map vs perc test.

By service

• Septic System Repair in Mount Juliet
• Septic Installation in Mount Juliet

Permitting in Wilson County

Septic permitting in Wilson County is administered by the State of Tennessee, not the county health department. See the Wilson County detail →