SepticRecord

Washington County

Septic services in Beverly, Ohio

Operators based within 12 miles of Beverly

Listed by where the business is, not by who it says it serves. Every operator here was on the ODH 2026 sewage treatment system bond lists on the date its record shows, and the address it is placed by comes from that same list, so this is a checkable claim rather than a service-area promise. An Ohio bond covers work in any health district in the state, though each district registers its contractors separately, so operators further out can work here too; these are simply the ones closest to you.

Soil and septic suitability around Beverly

The USDA has already rated this ground for exactly one use: a septic tank absorption field. Within 4 miles of Beverly — 32,037 acres across 168 soil map units — it rates 93.3% of the land very limited for that use and 1.5% somewhat limited, and almost none with no limitation at all.

What the limitation actually is

A rating on its own tells you nothing you can act on. The reasons do, and around Beverly the leading one is slope on 57.2% of the mapped area, followed by depth to bedrock on 56.3%. In full:

Limiting featureShare of areaWhat it means on site
Slope57.2%The ground is too steep for a conventional field
Depth to bedrock56.3%Bedrock is too shallow to fit a trench above it
Slow water movement49.4%Water moves through the soil too slowly for a drain field to keep up
Depth to saturated zone27%A seasonal water table sits too close to the surface
Seepage, bottom layer15.3%The layer beneath the trench is porous enough that effluent could reach groundwater without being filtered

Shares overlap: most soils here are limited for more than one reason at once, so these do not sum to 94.8%.

The soils themselves

The named soils and land types that make up most of the ground around Beverly. Upshur alone accounts for 23.6% of it.

Soil or land typeShareDrainageSlopeDepth to bedrockSeptic rating
Upshur23.6% Well drained 2 to 70% 23 in Very limited
Gilpin15.3% Well drained 2 to 70% 26 in Very limited
Summitville6.6% Moderately well drained 6 to 70% 24 in Very limited
Omulga4.3% Moderately well drained 2 to 18% None in profile Very limited
Zanesville3.8% Moderately well drained 1 to 15% 48 in Very limited

“None in profile” means SSURGO records no bedrock or other restrictive layer within the depth it describes, not that none exists.

Area of interest: a 4-mile radius around the USGS Geographic Names centre point for Beverly (GNIS 2398115, 39.5500, -81.6358), chosen because five of this state's communities are unincorporated and have no boundary to use, and because the lots that need a septic permit are in the ring around a town rather than inside it. Soil from USDA-NRCS Soil Data Access, SSURGO interpretation “ENG - Septic Tank Absorption Fields”, area-weighted by mapped acreage and by each component's share of its map unit. Survey areas: Morgan County, Ohio (2025-09-02), Noble County, Ohio (2025-09-02), Washington County, Ohio (2025-09-08). Retrieved 2026-09-18.

This is a survey, not an evaluation of your lot. The permit decision rests on the site evaluation ODH carries out for the specific parcel.

By service

Permitting in Washington County

In Washington County a septic (sewage treatment system) permit is issued by the local board of health, not by the state. The Ohio Department of Health writes the rules; the health district applies them and registers the contractors who work in it. See the Washington County detail →