SepticRecord

Hamilton County

Septic services in Collegedale, Tennessee

Operators based within 12 miles of Collegedale

Listed by where the business is, not by who it says it serves. Every operator here holds a current state permit, and the address it is placed by comes from the state's own published list — so this is a checkable claim rather than a service-area promise. A Tennessee installer permit is valid statewide, so operators further out can work here too; these are simply the ones closest to you.

Dawson

Verified against state license roster

Septic Installation · Septic System Repair

Website
none

Dirt Engineer

Verified against state license roster

Septic Installation · Septic System Repair

Website
none

Soil and septic suitability around Collegedale

The USDA has already rated this ground for exactly one use: a septic tank absorption field. Within 4 miles of Collegedale — 32,005 acres across 132 soil map units — it rates 81.2% of the land very limited for that use and 14.8% somewhat limited, and almost none with no limitation at all.

What the limitation actually is

A rating on its own tells you nothing you can act on. The reasons do, and around Collegedale the leading one is slope on 43% of the mapped area, followed by depth to bedrock on 35.9%. In full:

Limiting featureShare of areaWhat it means on site
Slope43%The ground is too steep for a conventional field
Depth to bedrock35.9%Bedrock is too shallow to fit a trench above it
Slow water movement23.7%Water moves through the soil too slowly for a drain field to keep up
Seepage, bottom layer19.3%The layer beneath the trench is porous enough that effluent could reach groundwater without being filtered
Depth to saturated zone16.9%A seasonal water table sits too close to the surface

Shares overlap: most soils here are limited for more than one reason at once, so these do not sum to 96%.

The soils themselves

The named soils and land types that make up most of the ground around Collegedale. Bodine alone accounts for 14.8% of it.

Soil or land typeShareDrainageSlopeDepth to bedrockSeptic rating
Bodine14.8% Somewhat excessively drained 2 to 45% None in profile Very limited
Fullerton11.5% Well drained 2 to 45% None in profile Very limited
Montevallo10.2% Well drained 5 to 45% 10 in Very limited
Armuchee5.3% Well drained 5 to 40% 21 in Very limited
Enders5.3% Well drained 2 to 25% 41 in Very limited

“None in profile” means SSURGO records no bedrock or other restrictive layer within the depth it describes, not that none exists.

What that means if you are building or repairing here

Steep ground

A drain field has to be close to level. Effluent is distributed along a trench by gravity or by pump, and on a grade it runs to the low end, overloads it, and surfaces there. Around Collegedale enough of the ground is steep that field placement tends to decide house placement rather than the other way round — the usable field area is often a bench or a shoulder some distance from the best building site, and the connection between them is a cost. It is worth knowing which part of a lot is the field before you fall in love with a view.

Shallow bedrock

This is limestone country, and around Collegedale the rock is close enough to the surface to be the governing constraint. A drain field is a shallow excavation: the trench has to sit in natural soil, with room beneath it for effluent to move down and be treated. Rock under the trench does not treat anything, and it cannot be solved by digging deeper or by blasting — breaking rock produces a hole, not a soil profile. What a shallow site usually means in practice is a shallow-placement or low-pressure pipe design, imported fill, or a field sited well away from the house on whatever part of the lot runs deepest — which is why a soil map is worth having before you decide where the house goes.

Area of interest: a 4-mile radius around the USGS Geographic Names centre point for Collegedale (GNIS 1280968, 35.0531, -85.0502), chosen because five of this state's communities are unincorporated and have no boundary to use, and because the lots that need a septic permit are in the ring around a town rather than inside it. Soil from USDA-NRCS Soil Data Access, SSURGO interpretation “ENG - Septic Tank Absorption Fields”, area-weighted by mapped acreage and by each component's share of its map unit. Survey areas: Bradley County, Tennessee (2025-08-28), Hamilton County, Tennessee (2025-08-28). Retrieved 2026-09-09.

This is a survey, not a soil map for your lot. A permit needs a high-intensity map of the specific parcel, produced by a TDEC-approved soil consultant — see soil map vs perc test.

By service

Permitting in Hamilton County

Hamilton is one of nine Tennessee contract counties that run their own septic program instead of the state's. County rules apply and, where stricter than the state's, control. See the Hamilton County detail →