Operators based within 12 miles of Pelham

Listed by where the business is, not by who it says it serves. Every operator here holds a current state permit, and the address it is placed by comes from the state's own published list — so this is a checkable claim rather than a service-area promise. A Tennessee installer permit is valid statewide, so operators further out can work here too; these are simply the ones closest to you.

Soil and septic suitability around Pelham

The USDA has already rated this ground for exactly one use: a septic tank absorption field. Within 4 miles of Pelham — 32,007 acres across 155 soil map units — it rates 67.1% of the land very limited for that use and 23.2% somewhat limited, and almost none with no limitation at all.

• Very limited · 67.1%
• Somewhat limited · 23.2%
• Not rated · 9.7%

What the limitation actually is

A rating on its own tells you nothing you can act on. The reasons do, and around Pelham the leading one is slope on 33.5% of the mapped area, followed by depth to saturated zone on 28.7%. In full:

Shares overlap: most soils here are limited for more than one reason at once, so these do not sum to 90.3%.

The soils themselves

The named soils and land types that make up most of the ground around Pelham. Waynesboro alone accounts for 9.9% of it.

“None in profile” means SSURGO records no bedrock or other restrictive layer within the depth it describes, not that none exists.

What that means if you are building or repairing here

Steep ground

A drain field has to be close to level. Effluent is distributed along a trench by gravity or by pump, and on a grade it runs to the low end, overloads it, and surfaces there. Around Pelham enough of the ground is steep that field placement tends to decide house placement rather than the other way round — the usable field area is often a bench or a shoulder some distance from the best building site, and the connection between them is a cost. It is worth knowing which part of a lot is the field before you fall in love with a view.

A seasonal water table

Some of the ground around Pelham carries a water table that rises close to the surface for part of the year and is nowhere to be seen for the rest of it. A field built into saturated soil does not treat effluent and does not drain, and the soil does not have to be wet on the day it is looked at for that to be true — the evidence is in the profile, as mottling and grey colours, which is one of the reasons the work is done by someone trained to read a soil pit rather than by timing water in a hole in August.

Area of interest: a 4-mile radius around the USGS Geographic Names centre point for Pelham (GNIS 1297123, 35.3101, -85.8808), chosen because five of this state's communities are unincorporated and have no boundary to use, and because the lots that need a septic permit are in the ring around a town rather than inside it. Soil from USDA-NRCS Soil Data Access, SSURGO interpretation “ENG - Septic Tank Absorption Fields”, area-weighted by mapped acreage and by each component's share of its map unit. Survey areas: Coffee County, Tennessee (2025-08-28), Franklin County, Tennessee (2025-08-28), Grundy County, Tennessee (2025-09-02). Retrieved 2026-09-09.

This is a survey, not a soil map for your lot. A permit needs a high-intensity map of the specific parcel, produced by a TDEC-approved soil consultant — see soil map vs perc test.

By service

• Septic System Repair in Pelham
• Septic Installation in Pelham

Permitting in Grundy County

Septic permitting in Grundy County is administered by the State of Tennessee, not the county health department. See the Grundy County detail →