SepticRecord

Giles County

Septic services in Lynnville, Tennessee

Operators based within 12 miles of Lynnville

Listed by where the business is, not by who it says it serves. Every operator here holds a current state permit, and the address it is placed by comes from the state's own published list — so this is a checkable claim rather than a service-area promise. A Tennessee installer permit is valid statewide, so operators further out can work here too; these are simply the ones closest to you.

DMC, Inc.

Verified against state license roster

Septic Installation · Septic System Repair

Website
none

SELF SERVICE, LLC

Verified against state license roster

Septic Installation · Septic Tank Pumping · Septic System Repair

Website
none

Soil and septic suitability around Lynnville

The USDA has already rated this ground for exactly one use: a septic tank absorption field. Within 4 miles of Lynnville — 32,007 acres across 130 soil map units — it rates 86.2% of the land very limited for that use and 12% somewhat limited, and almost none with no limitation at all.

What the limitation actually is

A rating on its own tells you nothing you can act on. The reasons do, and around Lynnville the leading one is slope on 49.9% of the mapped area, followed by slow water movement on 41%. In full:

Limiting featureShare of areaWhat it means on site
Slope49.9%The ground is too steep for a conventional field
Slow water movement41%Water moves through the soil too slowly for a drain field to keep up
Seepage, bottom layer29.7%The layer beneath the trench is porous enough that effluent could reach groundwater without being filtered
Depth to bedrock18.1%Bedrock is too shallow to fit a trench above it
Flooding16.9%The site floods often enough to matter

Shares overlap: most soils here are limited for more than one reason at once, so these do not sum to 98.2%.

The soils themselves

The named soils and land types that make up most of the ground around Lynnville. Dellrose alone accounts for 18% of it.

Soil or land typeShareDrainageSlopeDepth to bedrockSeptic rating
Dellrose18% Well drained 2 to 60% None in profile Very limited
Bodine13.4% Somewhat excessively drained 5 to 45% None in profile Very limited
Armour7.9% Well drained 0 to 20% None in profile Very limited
Mimosa7.8% Well drained 2 to 45% 51 in Very limited
Braxton6.1% Well drained 0 to 25% None in profile Very limited

“None in profile” means SSURGO records no bedrock or other restrictive layer within the depth it describes, not that none exists.

What that means if you are building or repairing here

Steep ground

A drain field has to be close to level. Effluent is distributed along a trench by gravity or by pump, and on a grade it runs to the low end, overloads it, and surfaces there. Around Lynnville enough of the ground is steep that field placement tends to decide house placement rather than the other way round — the usable field area is often a bench or a shoulder some distance from the best building site, and the connection between them is a cost. It is worth knowing which part of a lot is the field before you fall in love with a view.

Slow-draining soil

The ground around Lynnville holds water. Tennessee measures this as an absorption rate in minutes per inch, and slow soil does not fail a site so much as enlarge it: the slower the rate, the more trench length the same household needs, and past a point a conventional field stops being approvable at all. A slow site is normally still buildable on a low-pressure pipe or drip design, and that is the point at which the installer list matters, because most licence holders in Tennessee are not endorsed for either.

Karst, and why fast soil is not good soil

Part of the ground around Lynnville is limited not because water moves too slowly but because it moves too freely: fractured limestone beneath the trench that carries effluent down to groundwater before the soil has treated it. Much of Tennessee's limestone country is karst — sinkholes, solution channels, springs — and a great many households here draw drinking water from private wells. A site that percolates beautifully can still be refused for exactly that reason, and the separation distances between a field, a sinkhole and a well are among the things a soil consultant is actually looking for.

Area of interest: a 4-mile radius around the USGS Geographic Names centre point for Lynnville (GNIS 1292366, 35.3767, -87.0061), chosen because five of this state's communities are unincorporated and have no boundary to use, and because the lots that need a septic permit are in the ring around a town rather than inside it. Soil from USDA-NRCS Soil Data Access, SSURGO interpretation “ENG - Septic Tank Absorption Fields”, area-weighted by mapped acreage and by each component's share of its map unit. Survey areas: Giles County, Tennessee (2025-08-28), Marshall County, Tennessee (2025-08-29), Maury County, Tennessee (2025-08-29). Retrieved 2026-09-09.

This is a survey, not a soil map for your lot. A permit needs a high-intensity map of the specific parcel, produced by a TDEC-approved soil consultant — see soil map vs perc test.

By service

Permitting in Giles County

Septic permitting in Giles County is administered by the State of Tennessee, not the county health department. See the Giles County detail →