SepticRecord

Fentress County

Septic services in Jamestown, Tennessee

Operators based within 12 miles of Jamestown

Listed by where the business is, not by who it says it serves. Every operator here holds a current state permit, and the address it is placed by comes from the state's own published list — so this is a checkable claim rather than a service-area promise. A Tennessee installer permit is valid statewide, so operators further out can work here too; these are simply the ones closest to you.

Delk

Verified against state license roster

Septic Installation · Septic System Repair

Website
none

Soil and septic suitability around Jamestown

The USDA has already rated this ground for exactly one use: a septic tank absorption field. Within 4 miles of Jamestown — 32,015 acres across 25 soil map units — it rates 77.7% of the land very limited for that use and 12.8% somewhat limited, and almost none with no limitation at all.

What the limitation actually is

A rating on its own tells you nothing you can act on. The reasons do, and around Jamestown the leading one is seepage, bottom layer on 62.7% of the mapped area, followed by depth to bedrock on 62.2%. In full:

Limiting featureShare of areaWhat it means on site
Seepage, bottom layer62.7%The layer beneath the trench is porous enough that effluent could reach groundwater without being filtered
Depth to bedrock62.2%Bedrock is too shallow to fit a trench above it
Slope58%The ground is too steep for a conventional field
Slow water movement6.6%Water moves through the soil too slowly for a drain field to keep up
Large stones5.7%

Shares overlap: most soils here are limited for more than one reason at once, so these do not sum to 90.5%.

The soils themselves

The named soils and land types that make up most of the ground around Jamestown. Lily alone accounts for 29.8% of it.

Soil or land typeShareDrainageSlopeDepth to bedrockSeptic rating
Lily29.8% Well drained 3 to 8% 36 in Very limited
Ramsey13.9% Somewhat excessively drained 5 to 35% 18 in Very limited
Alticrest9.6% Well drained 5 to 20% 32 in Very limited
Gilpin7.9% Well drained 5 to 40% 30 in Somewhat limited
Rock outcrop6.7% 5 to 60% 0 in Not rated

“None in profile” means SSURGO records no bedrock or other restrictive layer within the depth it describes, not that none exists.

What that means if you are building or repairing here

Karst, and why fast soil is not good soil

Part of the ground around Jamestown is limited not because water moves too slowly but because it moves too freely: fractured limestone beneath the trench that carries effluent down to groundwater before the soil has treated it. Much of Tennessee's limestone country is karst — sinkholes, solution channels, springs — and a great many households here draw drinking water from private wells. A site that percolates beautifully can still be refused for exactly that reason, and the separation distances between a field, a sinkhole and a well are among the things a soil consultant is actually looking for.

Shallow bedrock

This is limestone country, and around Jamestown the rock is close enough to the surface to be the governing constraint. A drain field is a shallow excavation: the trench has to sit in natural soil, with room beneath it for effluent to move down and be treated. Rock under the trench does not treat anything, and it cannot be solved by digging deeper or by blasting — breaking rock produces a hole, not a soil profile. What a shallow site usually means in practice is a shallow-placement or low-pressure pipe design, imported fill, or a field sited well away from the house on whatever part of the lot runs deepest — which is why a soil map is worth having before you decide where the house goes.

Steep ground

A drain field has to be close to level. Effluent is distributed along a trench by gravity or by pump, and on a grade it runs to the low end, overloads it, and surfaces there. Around Jamestown enough of the ground is steep that field placement tends to decide house placement rather than the other way round — the usable field area is often a bench or a shoulder some distance from the best building site, and the connection between them is a cost. It is worth knowing which part of a lot is the field before you fall in love with a view.

Area of interest: a 4-mile radius around the USGS Geographic Names centre point for Jamestown (GNIS 1289287, 36.4276, -84.9319), chosen because five of this state's communities are unincorporated and have no boundary to use, and because the lots that need a septic permit are in the ring around a town rather than inside it. Soil from USDA-NRCS Soil Data Access, SSURGO interpretation “ENG - Septic Tank Absorption Fields”, area-weighted by mapped acreage and by each component's share of its map unit. Survey areas: Fentress and Pickett Counties Area, Tennessee (2025-09-02). Retrieved 2026-09-09.

This is a survey, not a soil map for your lot. A permit needs a high-intensity map of the specific parcel, produced by a TDEC-approved soil consultant — see soil map vs perc test.

By service

Permitting in Fentress County

Septic permitting in Fentress County is administered by the State of Tennessee, not the county health department. See the Fentress County detail →